Wi-Fi Protected Setup (Wps); Using Wps To Connect To A Network - Epson ES-400 II User Manual

2. Press and hold the
when the
When the
Parent topic:

Wi-Fi Protected Setup (WPS)

If your network uses a WPS-enabled wireless router, you can quickly connect your scanner to the
network using Wi-Fi Protected Setup (WPS).
Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router. If there is
no hardware button, there may be a WPS setting in the software for the device. Check your network
product documentation for details.

Using WPS to Connect to a Network

Using WPS PIN Mode to Connect to a Network
Parent topic:
Using WPS to Connect to a Network
If you have a WPS-enabled wireless router, you can use Wi-Fi Protected Setup (WPS) to connect your
scanner to the network. Make sure you have installed your scanner software as described on your
scanner Start Here sheet.
Note: For best results, re-install your scanner software and follow the on-screen instructions to connect
to a network.
1. Open the scanner's input tray.
2. Enable WPS on your router by pressing and holding the WPS button on your wireless router until the
security light flashes or by enabling the WPS setting in your router firmware.
The router enters WPS discovery mode for 2 minutes.
Note: If you cannot locate the WPS button, or there are no buttons on the router or access point, see
the documentation provided with your router for details.
Wi-Fi connect button on the scanner for at least 3 seconds, then release it
Wi-Fi light flashes blue.
Wi-Fi light on the scanner stays on, the connection is established.
Direct Wi-Fi Mode (AP Mode) Setup
Wi-Fi Networking
50