BH FITNESS H855 Instructions For Assembly And Use page 45

ELECTRONIC MONITOR
To give you greater control over your
exercise, this electronic unit provides
simultaneous read-outs
distance, exercise time, calories burnt
and pulse rate.
If at any time during exercise you
press the START/STOP button then
all of the unit's functions will stop.
Pressing the START/STOP button
again will restart the machine.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
FITTING THE BATTERIES
This monitor uses four 1.5 volt
ALKALINE BATTERIES. To fit the
batteries, Figure 1, carefully insert the
«R-14» type alkaline batteries into the
battery compartment (A) making sure
that the
correct(matching the battery's «+»
terminalwith the «+» signinside the
battery compartment, and the «-»
terminal with the «-» sign). Place the
cover back on, Figure 1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important. Discarded batteries must
be deposited in special containers,
Figure 2.
of speed,
battery's polarityis
English
FITTING THE ELECTRONIC
MONITOR
FITTING THE HAND-GRIP CABLE
(Pulse sensors)
Take cable (25) coming out of the
handlebar stem and connect it to
cable (35) coming out of the monitor,
Figure 3.
FITTING THE MAIN CABLE
Connect
coming out of the monitor, Figure 3, to
the terminal block (9) coming out of
the handlebar stem and place the
monitor in the chain cover
MONITOR SCREEN
BRIGHTNESS LEVEL
ADJUSTMENT
1- Switch the monitor on in STOP
mode.
2-Press the "ENTER" and "UP" keys
simultaneously. After about 2 seconds
the monitor will beep.
3- Use the "UP" and "DOWN" keys to
increase or decrease the brightness
level.
4- Press any key to save the
brightness setting and return to STOP
mode.
MONITOR FUNCTIONS
This monitor has six keys: ENTER,
TEST, DOWN, UP, START/ STOP,
MODE. The program level you have
selected is shown simultaneously in
the central section of the display. The
six windows at the bottom of the
display show the TIME; RPM/ SPEED;
DISTANCE/ODOMETER
distance covered); CALORIES/WATT;
THR (TARGET HEART RATE); AGE;
8
the terminal block (12)
(total