Table of Contents
Advertisement
1
Getting started
The EVL62XX evaluation environment covers a wide range of applications and it is ready to be used in a few
steps.
Follow this procedure to start your evaluation:
1.
Check the setting of the jumpers based on your configuration as described in Section 2: "Hardware
description and configuration".
2.
Connect the plug-in board onto the main board.
3.
Connect the main board with the STM32 Nucleo board through Arduino UNO R3.
4.
Supply the board through the input 1 (VS) and 2 (ground) of the connector CN3.
Further support material is available on the respective product pages on www.st.com.
UM2871 - Rev 1
UM2871
Getting started
page 2/26
Advertisement
Table of Contents
Need help?
Do you have a question about the L62 Series and is the answer not in the manual?