Kemppi A5 MIG Rail System 2500 Operating Manual page 9

Speed Car
P1 CH on
Speed Car 8cm/m
Set the carriage travel speed:
1. Use + and – buttons to change the speed.
2. Set the carriage speed within the range
5–150 cm/min.
3. Press MENU button to continue.
Speed
P1 CH on
Speed <-> 45mm/s
Set the weaving speed i.e. the speed at which the torch
moves from one side of the groove to the other during
the weaving motion:
1. Use + and – buttons to change the speed.
2. Set the weaving speed within the range
10–50 mm/s.
3. Press MENU to continue.
© Kemppi Oy 2021
Width
Set the width of the weaving motion:
9
A5 MIG Rail System
P1 CH on
Width <-> 6mm
1. Use + and – buttons to change the width from
center (1 mm = 0.5 mm on each side).
2. Set the weaving width within the range 0–30 mm
3. Press MENU to continue.
R01