Battery System Installation - Alpha ESS STORION-T50 Installation Manual

INSTALLATION
A≥1,000mm, make sure that the front door of the cabinet can be fully opened and there
is sufficient space for cold air to enter. Users can conveniently insert and extract the
module and operate the breaker.
B≥1,000mm, make sure that the rear door of the cabinet can be fully opened. Ventilation
and heat dissipation should be ensured. Users can also have sufficient space for product
maintenance.
4.3.1.3 Cabinet Installation
After the cabinet is removed to the installation position with a forklift or a tool. The
cabinet should be adjusted and removed to the designed position. Then open the internal
door of cabinet, and fix the cabinet with M13 screws, as shown in Figure 4-3.
Figure 4-3 Diagram of the cabinet base
When the cabinet needs to be fixed on the steel channel, Φ14 holes can be made in the
steel channel. Fix the cabinet to the steel channel with screws, as shown in Figure 4-4.
Fixed screw
Channel
steel
Cable
groove
Figure 4-4 Fix the cabinet
to the steel channel
When the cabinet is fixed to the concrete floor, make holes on the floor and fix the
cabinet to the concrete floor with expansion screws, as shown in Figure 4-5.
Front side of cabinet
723.5
678
8-14X24 waist hole
Ground
Foot screw
Cable
groove
Figure 4-5 Fix the cabinet
to the concrete floor
19 20

4.3.2 Battery System Installation

4.3.2.1 Battery Rack Installation
That depends on the customer
4.3.2.2 Battery Installation
Figure 4-6 Battery packages
Step1: Open all the battery packages.
Step 3: Put the same cluster of batteries on the same rack with the serial number of 01
to 09 from top to bottom as the above figure shows. The dip switch defines the
serial number, see Table 6.
Note: All the cluster battery group No. shall be the same.
In one cluster the dip switch of each battery should be different from others.
When you are installing the battery, please to avoid scratches because of the heavy
battery.
Battery SN
Battery Group Number
Figure 4-7 Battery label information
Step2: Check the Battery No. and cluster
No. on the battery cover.
BAT1-9
BAT1-8
BAT1-7
BAT1-6
BAT1-5
......
BAT1-4
BAT1-3
BAT1-2
BAT1-1
1#HV900112
Figure 4-8 Installation the battery
INSTALLATION
Battery Number in One Cluster
Cluster Number
BAT9
BAT8
BAT7
BAT6
BAT5
BAT4
BAT3
BAT2
BAT1
N#HV900112