Fall Stop Assembly (Refer To Figure 14) - R&M LOADMATE LM16 Installation And Maintenance Manual

LM16-20-25 I&M MANUAL/EN/11.30.2010
6.9

Fall Stop Assembly (Refer to Figure 14)

The slack fall stop is a safety stop, not a functional stop. The fall stop must be located at least six
(6.0) inches [150mm] from end of last chain link.
Figure 14. Cross Section of Slack Fall Stop
Removing Fall Stop Assembly
1. Loosen and remove nut (two each for
2. Remove bolts.
3. Remove two halves of Fall Stop.
4. Remove limit switch washer plate and spring.
Installing Fall Stop Assembly
1. Install limit switch washer plate and spring unto chain. Make certain washer is in proper position to
contact limit switch.
2. Place two halves of Fall Stop at least six (6) inches [150mm] from end of chain.
3. Insert bolt and tighten nut (two each for
R&M Materials Handling, Inc. | 4501 Gateway Boulevard, Springfield, Ohio 45502 | PH: 1-937-525-5100 | FAX: 1-937-325-5319
This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that
may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.
Copyright © (2010) R&M Materials Handling, Inc. All rights reserved.
P25019
LM 16
LM 20/25 )
LM 20/25 )
LM 20 / 25
33/73