Fall Stop Assembly; General; Fall Stop Installation - R&M LOADMATE LM Series Installation And Maintenance Manual

LM01 I&M MANUAL/EN/11.30.2010
5.5

Fall Stop Assembly

5.5.1 General

The slack fall stop is a safety stop, not a functional stop. The fall stop must be located at least six
(6.0) inches [150mm] from end of last chain link.
Figure 8. Cross Section of Slack Fall Stop

5.5.2 Fall Stop Installation

1. Position two fall stop halves (item 1, Figure 8) on chain link at least six (6.0") inches [150mm] from
end of load chain.
2. Insert screw (item 2) through fall stop halves and chain link.
3. Tighten nut (item 3) per torque setting in section 6.4.
This document and the information contained herein, is the exclusive property of R&M MATERIALS HANDLING, INC. and represents a non-public, confidential and proprietary trade secret
that may not be reproduced, disclosed to third parties, altered or otherwise emplo yed in any manner whatsoever without the express written consent of R&M MATERIALS HANDLING, INC.
Copyright © (2010) R&M MATERIALS HANDLING, INC. All rights reserved.
28/65