R&M LOADMATE LM16 Installation And Maintenance Manual page 29

Hide thumbs Also See for LOADMATE LM16:

Installation & maintenance instructions manual (58 pages)

Installation and maintenance manual (89 pages)

Operator's manual (42 pages)

Table Of Contents

Table of Contents

LM16-20-25 I&M MANUAL/EN/11.30.2010

Figure 12. Chain Dimensions

P25004

Measure the following chain dimensions at several points on chain: ( Figure 12 )

Dimensions of one link ( d x t ) where, d = diameter and t = pitch

Length over 11 links ( 11 t )

Replace load chain if any one of these dimensions exceeds maximum allowed wear:

Maximum allowed wear:

Minimum link diameter allowed

Maximum pitch allowed

Maximum length allowed

NOTE: If load chain needs replaced, then inspect chain guide and chain (load) wheel on

hoist and idler sprocket in 2-fall load block for excessive wear. A chain sprocket showing

evidence of scored pockets or sharp edges generated from wear SHALL be replaced. A

worn chain sprocket or idler sprocket can greatly reduce the life of load chain.

R&M Materials Handling, Inc. | 4501 Gateway Boulevard, Springfield, Ohio 45502 | PH: 1-937-525-5100 | FAX: 1-937-325-5319

This document and the information contained herein, is the exclusive property of R&M Materials Handling, Inc., and represents a non-public, confidential and proprietary trade secret that

may not be reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of R&M Materials Handling, Inc.

Ød

LM 16

9.0 x 27.0 chain

(d):

0.319"

(t):

1.114"

(11t):

11.929" [300 mm]

11 t

LM 20 / 25

11.3 x 31.0