Disassembling The Charging Station; Assembling The Charging Station - Husqvarna Automower 320 Technical Manual

5.3 Disassembling the charging
station
Replacing the antenna plate in the charging station
also requires that the charging tower is detached
from the charging station (see points 6 and 7 below).
To replace e.g. a circuit board or a contact strip,
it is sufficient to remove the cover from the charging
station.
1. Disconnect the transformer.
2. Disconnect all cables from the charging
station, i.e. low voltage cable, boundary
wire and guide wires.
3. Loosen the two screws (Torx 20) on the
front of the charging tower.
4. Carefully lift the charging cover forward and
upward from the charging tower until the
cover comes away from the tower.
5. Disconnect the charging cables and the
PARK cables (only 330X) from the main
circuit board.
6. If the antenna plate must be disconnected
from the charging tower, the four screws
(Torx 20) underneath the charging station
must be loosened.
7. Disconnect the connector with the signal
cables from the main circuit board and prise
out the rubber grommet from the tower.
5.4 Assembling the charging
station
Assembling the charging station takes place in
reverse order to 5.3 Disassembling the charging
station on page 62. Make sure that no cables are
pinched and that the rubber grommet for the signal
cables are in place.
English - 62
5. REPAIR INSTRUCTIONS