Husqvarna Automower 320 Technical Manual page 59

5.2.1 Disassembling the body
The body is fitted to the chassis using four quick-
mounted, snap-on brackets. The charging cable
fastened to the body's charging strip must be
disconnected to be able to remove the body entirely
from the chassis.
1. Set the main switch to position 0.
2. Clean the area around the grommet for the
charging cable found at the very front under
the mower.
3. Pull out the rubber grommet on the charging
cable and carefully loosen the connector.
4. Loosen the body from the chassis by lifting
the body one corner at a time while holding
the chassis in place.
5.2.2 Disassembling the chassis
The chassis consists of upper and lower sections.
These are screwed together with 14 screws.
1. Disassemble the body. See 5.2.1
Disassembling the body on page 57.
2. Loosen all 14 screws (Torx 20).
3. Remove the guarantee seal at the point
of separation between the chassis halves
on the right-hand side.
5. REPAIR INSTRUCTIONS
English - 57