Husqvarna Automower 320 Technical Manual page 69

IMPORTANT INFORMATION
Only touch the edges of the circuit board.
Never touch the board's components and
pin terminals.
7. Pull off the keypad and thread the cable out
through the hole.
8. Remove the protective film from the new
keypad and then press new keypad onto the
display cover. Remember to thread the cable
through the hole in the display cover.
Make sure to press the keypad carefully and
firmly into position. There must not be any
loose corners or air bubbles as this can cause
dirt and moisture to get in under the keypad.
9. Fit the MMI circuit board. Carefully bend away
the snap-on fasteners to facilitate assembly.
10. Reconnect all cables to the MMI circuit board.
11. Refit the display cover, chassis and body.
5. REPAIR INSTRUCTIONS
English - 67