Advertisement
SERVICE MANUAL
A
Rotation side
ANGLE ADJUSTMENT
Leave the footplate engaged in the using position.
Loosen the bolt A of both adjustment supports.
Turn the plate frontward or backward.
Once reached the correct inclination, tighten the bolt A on the lock side.
Check the footplate engages and disengages easily (you may need to make a minor angle
adjustment working on the plate) and then tighten the bolt A of the rotation
Note: this kind of footplate allows for the plate to be turned 180°, therefore, before proceeding
with the adjustment, raise the plate from the lock side and turn it until its rotation stops.
This rotation allows for a temporary opposite position of the plate, but it also helps to reduce
the encumbrance if the plate, in its normal use, is positioned "external".
To carry out such operation, just raise the plate from the lock support and turn it tp the opposi-
te position; then engage it to the lock support normally.
POSITIONING
2 positions: internal; external
11
INTERNAL
REVERSING THE FOOTPLATE
1) Loosen the angle adjustment bolts A and slide off the lock and rotation sides supports
from the tube and assemble them reversing their position.
2) Or, remove the tubes, follow instructions of chapter
reversing their side.
Finally, adjust the inclinantion
When reversing the footplate in either these two methods, you change the lock side, too.
Note: the pictures show the footplate assembled another model of wheelchair; the instructions are the same.
REHATEAM s.r.l.—vicolo Negrelli 5—31038 Castagnole di Paese TV - www.rehateamprogeo.com
ONE PIECE FLIP-UP CARBON FOOTPLATE
footplate distance and assemble them
and tighten the bolts A— see also "angle adjustment".
Lock side
side.
EXTERNAL
A
Follows next page
Service Manual VARIO CARBON 26
A
A
Advertisement
