Advertisement
SERVICE MANUAL
A
Rotation side
ANGLE ADJUSTMENT
Leave the footplate engaged in the using position.
Loosen the bolt A of both adjustment supports.
Turn the plate frontward or backward.
Once reached the correct inclination, tighten the bolt A on the lock side.
Check the footplate engages and disengages easily (you may need to make a minor angle
adjustment working on the plate) and then tighten the bolt A of the rotation
POSITIONING
4 positions: internal; 2/3 internal; 2/3 externa (not present in the order form); external
INTERNAL
Note: the pictures show the footplate assembled another model of wheelchair; the instructions are the same.
REHATEAM s.r.l.—vicolo Negrelli 5—31038 Castagnole di Paese TV - www.rehateamprogeo.com
ONE PIECE FLIP-UP PLASTIC FOOTPLATE
2/3 INTERNAL
It is possible to change the footplate position in different ways
1) Loosen the angle adjustment bolts A and remove the lock side support and the rotation side
support from the tubes and assemble them exchanging their position.
2) Remove the tubes following the instructions of the chapter footplate distance and assemble
them again exchanging their position.
Finally, adjust the angle adjustment.
Using either of these two methods, you can turn the footplate position from internal to external
(or vice versa) or from 2/3 internal to 2/3 external (or vice versa).
When reversing the footplate in either these two methods, you change the lock side, too.
Lock side
side.
2/3 EXTERNAL
Service Manual VARIO CARBON 22
A
11.5 cm
EXTERNAL
Follows next page
Advertisement
