Download Print this page

progeo VARIO CARBON Service Manual page 25

Hide thumbs Also See for VARIO CARBON:

Advertisement

SERVICE MANUAL
A
CHANGING THE LOCK SIDE WHILE KEEPING THE SAME PLATE POSITION
Reverse the footplate position as above indicated on point 1 of the chapter "reversing the footplate".
The footplate tubular is fixed to the rotation support and to the lock support with two bolts C each.
Lift the footplate.
Remove the two bolts C of the lock support and slide it off the footplate tubular.
Remove the two bolts C of the rotation support and slide the footplate out of it
Should the bolts be too hard to unscrew, you will have to heat them up in order to make the thread lock glue lose its efficiency.
Spread some mild or strong thread lock glue on the bolts C.
Insert the lock and rotation supports on the footplate tubular opposite and fix them with the bolts C.
Pay attention when fixing the rotation support, in fact, it can rotate on one direction only (if it is mounted opposite, the footplate can only ro-
tate downward).
Adjust the inclination
and tighten the bolts A— see also "angle adjustment".
ROTATION SIDE
FRICTIONING THE ROTATION
To adjust the friction of the footplate rotation movement, tighten or
loosen the bolt D.
It is advisable to remove the bolt, squeeze a little part of its thread
with a long nose pliers, spread a drop of strong thread lock glue,
insert it and screw it. In fact, the movement of the footplate can lead
that bolt to unscrew itself. Usually, when the footplate is lifted up the
adjustment holds it in place.
Note: the pictures show the footplate assembled another model of wheelchair; the instructions are the same.
REHATEAM s.r.l.—vicolo Negrelli 5—31038 Castagnole di Paese TV - www.rehateamprogeo.com
ONE PIECE FLIP-UP ALUMINUM FOOTPLATE
REVERSING THE FOOTPLATE
1) Loosen the angle adjustment bolts A and slide off the lock and rotation sides supports from
the tube and assemble them reversing their position.
A
2) Or, remove the tubes, follow instructions of chapter
reversing their side.
Finally, adjust the inclinantion
Using either of these two methods, you can turn the footplate position from internal to external
(or vice versa) or from 2/3 internal to 2/3 external (or vice versa).
When reversing the footplate in either these two methods, you change the lock side, too.
LOCK SIDE
C
and tighten the bolts A— see also "angle adjustment".
LOCK SIDE
FOOTPLATE WITHOUT SUPPORTS
footplate distance and assemble them
ROTATION SIDE
D
D
Service Manual VARIO CARBON 25

Advertisement

loading