Advertisement
SERVICE MANUAL
F1 F2
B
A
You can adjust the setting by changing the position of the receiver B with respect to the plate A, but also by turning the plate.
To carry out the adjustment, simply remove the receiver B and its parts (nut X, washer Y and, if present, spacers Z) and fix it to the new
position. The interval between the two holes is 25 mm.
You can use the spacers Z in case you need to have the rear wheel more external.
In Even if the holes F of the plate are 2, the possible settings are 4.
In fact, the 2 holes are not centred with respect to the plate, thus, if you turn the plate by 180°, the position of the holes with respect to the
frame, change.
D
C
To turn the plate, remove the 6 bolts C. The plate A and the fixing blocks D come off.
Mounting the plated reversed: fit the 3 bolts C on both fixing block D in such a way
that you can slide the plate along the frame.
Fix the plate following the instructions of the chapter "rear height".
In the picture with the two plates in comparison, you can see the 4 possible settings.
In case of cambered wheels, check if it is correct — see chapter "camber and con-
vergency".
After changing the setting, adjust the mudguard and brake. Also, check and adjust
the front fork angle.
REHATEAM s.r.l.—vicolo Negrelli 5—31038 Castagnole di Paese TV - www.rehateamprogeo.com
SETTING ADJUSTMENT (point of balance)
C
D
A
B
Prudential 40 mm
Standard 55 mm
F2
F1
F1
F2
F1
F1
Active 65 mm
Service Manual VARIO CARBON 9
Z
Y
X
C
F2
F2
Extreme 80 mm
Advertisement
