Advertisement
SERVICE MANUAL
HEIGHT ADJUSTMENT EVERY 1.5cm
Remove the bolts A and their corresponding nuts and washers B.
Slide the footplate tube up or down until the necessary height.
Insert the bolts through the nearest holes and tighten.
If the tube does not slide over a certain height, DO NOT force it, you may irre-
deemably damage the frame.
Do not exceedingly tighten the bolts, you may irredeemably damage the frame.
If necessary, you can adjust the height of the two independent footplates differently.
With one piece footplate, the two tube have, of course, to be adjusted at the same height.
The footplate tube can be either short (1) or long (2).
The short tube has two positionings for the adjustment support (RH and LH) in order to
reach short footplate distances.
The long tube has only one positioning for the adjustment support and it is design for long-
er footplate distances.
The tubes for double footplates and one piece footplates are the same, but the adjustment
support is different.
To reach the shortest footplate distance, one can, both at original assembly or afterwards,
cut off both the footplate tube and the part of the frame just below the swelling as shown
by the dotted line C on the pictures at the top of the page.
It should be clear that the possible adjustment is then limited.
The adjustment support is fixed to the tube with the bolt D on which a drop of strong lock
thread glued is spread. Should you need to change the position of the support (only short
tube), in order to unscrew the bolt, you may need to heat it first. When you assemble the
support, spread a drop of strong lock thread glue on it.
After adjustment, check that between the lower side of the footplate and the ground there
is at least 2 cm and that there is no interference between footplate and casters.
REHATEAM s.r.l.—vicolo Negrelli 5—31038 Castagnole di Paese TV - www.rehateamprogeo.com
FOOTPLATE DISTANCE
A
B
swelling
C
40 mm
DOUBLE FOOTPLATE
1
ONE PIECE FOOTPLATE
1
D
Service Manual VARIO CARBON 20
2
2
Advertisement
