Advertisement
SERVICE MANUAL
Advice for drilling. While drilling a hole, such hole may result slightly moved with respect to the precise point you marked. For the first hole,
that move does not cause any trouble. On the other hand, for the second and third hole, it may cause a non-alignment between hole on the
side guard and hole on the blade. A good method to be more precise, once you reach point 5, is to use a 4 mm drill pin (in order to avoid
damaging the thread of the hole on the blade) and drill the side guard. Then, use and let a M5 tap through the threaded hole of the blade
and out of the side guard.
B
WHEN YOU INCREASE THE REAR HEIGHT, you have to move the side guard down.
X
If the lower side of the side guard is in contact with the support, it is necessary to cut it.
1. Measure the distance X from side guard and tyre and subtract 5 mm (es: 18-5 = 13 mm to cut).
2. Remove the three bolts H to take the side guard off the blade.
3. Draw the cut line according to the result you got.
4. Saw the side guard along the drawn line and round off the edges with a scissors blade or thin sand paper.
5. Continue with instruction
C
WHEN YOU CHANGE THE SETTING, you have to move the side guard frontward or backward according to the new position of the rear
wheel, but the height of the side guard remains the same.
A
Proceed with instruction
D
WHEN YOU CHANGE BOTH THE REAR HEIGHT AND THE SETTING, you have to move the side guard up or down and forward or
backward.
A
Continue with instruction
REHATEAM s.r.l.—vicolo Negrelli 5—31038 Castagnole di Paese TV - www.rehateamprogeo.com
SIDE GUARD
Removable with blade system
A
.
.
and, if necessary, instruction
B
B
, too.
Service Manual VARIO CARBON 13
Advertisement
