Advertisement
SERVICE MANUAL
C
When you change the setting, you have to
move the side guard frontward or backward
according to the new position of the rear
wheel, but the height of the side guard re-
mains the same.
1. After the setting adjustment, remove the
bolt D.
2. Loosen the two bolts fixing the plate of
support B to the frame.
3. Put the wheel on and slide the plate B forward or backward. Position the side guard at 5 mm from the tyre. If necessary, you can loosen
the bolt and nut C (C1 C2) and slide the side guard along the slot of the plate. The clamp F of the plate can be fixed ahead or behind the
frame fixing bolt(washer/nut G. to move the plate, you need to remove it after screwing off the two bolts E.
4. Tighten the two bolts E making sure to fix the plate perpendicular to the ground.
5. You have now to drill a new hole for the bolt D. With a pointed tool through the hole of the ring A, make a mark on the side guard.
6. Drill a 6 mm hole
7. Insert the bolt and washer D and fix the side guard. Make sure to fix bolt and nut C1 C2 , too.
8. Check and if necessary adjust the brake.
F
D
When you change both the rear height and the setting, you have to move the side guard
up or down and forward or backward.
1. After the rear wheel height and position adjustment, remove the bolt D and the bolt and
nut C1 C2. This way you remove the side guard.
2. Put the wheel on.
3. Adjust the brake by moving the plate of support B along the frame (see points 2 and 3 of
the adjustment C) - see also chapter "brake adjustment".
4. Position and hold with one hand the side guard at approximately 5 mm from the tyre and
parallel to it if (you can lean the side guard on the outside of the plate of support as in
adjustment B).
5. You have now to drill a new hole for the bolt D, thus, while holding the side guard in posi-
tion, make a mark on the side guard with a pointed tool through the hole of the ring A.
6. Drill a 6 mm hole.
7. Insert the bolt and washer D and fix the side guard.
8. Follow points 4 to 8 of adjustment
9. If the slots of the plate B do not allow fixing the side guard, you may move it accordingly.
10.Finally check and, if necessary, adjust the brake.
REHATEAM s.r.l.—vicolo Negrelli 5—31038 Castagnole di Paese TV - www.rehateamprogeo.com
SIDE GUARD
G
G
A
or
B
according to the adjustment.
C
B
F
Service Manual VARIO CARBON 11
E
B
E
Advertisement
