Intellitronix DP1011 Installation Manual page 8

Warning: If, while in 'CAL' mode, you do not move the vehicle and press the button
again, the microprocessor will NOT have received any data. The unit will display 'Err'
and will revert to the factory settings. At a minimum, drive some distance and return to
the start if necessary. If you miss stopping the display at 'CAL', simply repeat the steps.
Trip Distance
A single tap of the recall button will activate the trip meter in the odometer display. A decimal point
will appear which will indicate that you are in trip meter mode. Holding the recall button will clear
out the trip distance. To return to the default odometer display, tap the recall button again. The
decimal point will disappear, indicating that you are back in the default odometer display.
Setting the Odometer
While scrolling through 'CAL' mode you will see 'ODO' appear. This will allow you to enter the
vehicle's actual mileage. Press the trip button again at this point and you will enter the odometer set up
mode. Press quickly to change the number of the digit on the right. Press and hold to advance to the
next digit. Do this for all 5 digits. For Example: To enter the mileage reading 23456 into the odometer,
at the 'ODO' prompt, tap the small black button (quickly) two times, until the number 2 is dis- played.
Then press and hold the button until the numbers 20 are displayed. Tap the button 3 times until 23 is
displayed. Press and hold the button until 230 is displayed and continue in this manner until 23456 is
displayed. The speedometer will advance to the home screen, five seconds after the last number is
entered.
Recording and Viewing Performance Data
Follow these steps to record and recall Performance Data (high speed, ¼mile ET, and 0-60 time):
1. Before each run, your car must be at a complete stop at the starting position. Press and hold the push-
button as it cycles through the performance data. At the end, the odometer will re-set and all
performance data will be cleared. This will not affect your stored calibration value or the odometer
reading.
2. Press the push-button until 'HI-SP' is displayed. The gauge will automatically cycle through the
performance data.
3. Start the run, pass, session, etc., as mentioned above.
4. When finished, repeat Step 2 to view the data gathered from the run. While stopped, you can view
this data as often as you wish. However, once it finishes scrolling one time, the memory is ready to
record new data and will begin recording again once the vehicle starts to move. The highest speed
measured over multiple runs will be retained in memory.
# # #
8 – DP1011 Intellitronix www.intellitronix.com
(rev.02/27/20)