Dimensions - Valor H4 Series Installation & Owner's Manual

3" (76 mm) min.
To side wall from
inner frame
in front of
the appliance
NOTE: Backing plate requires a MINIMUM of 1/2" (13 mm) space
to floor/hearth in front for air flow. Raise the appliance accordingly.
0–2"
Mantel depth "A"
(0–51 mm)
Mantel height
31-1/4"
(794 mm)
"B"
Fronts and Trims
For fronts and trims dimensions, refer to instructions
provided with each kit.
Floor/Hearth
This appliance is approved for installation directly on
combustible material such as plywood and so on. Vinyl,
carpet, and soft fl ooring require sheet metal extending
the whole width and depth under the appliance.
This appliance does not require a hearth. Combustible
fl ooring may extend up to the front of the unit.
MINIMUM 3/4" (19 mm)
clearance to combustible
at rear
Stand-off
32-3/16" (817 mm)
Stand-off
2–4" 4–6"
(51–102 mm) (102–152 mm)
34" 35"
(864 mm) (889 mm)

Dimensions

8-1/4" (210 mm)
From finished
wall surface
to top vent
MINIMUM
3/4" (19 mm)
from finished
wall surface
to front of
appliance
36"
(914 mm)
min.
See
table
7-7/8"
(199 mm)
6–8" 8–10"
(152–203 mm) (203–254 mm)
36" 37"
(914 mm) (940 mm)
Combustible Materials Specifi cations
Materials made of or surfaced with wood, compressed
paper, plant fi bers, plastics, or other material that
can ignite and burn, whether fl ame proofed or not,
or plastered or unplastered shall be considered
combustible materials.
Non-Combustible Materials Specifi cations
Material which will not ignite and burn. Such materials
are those consisting entirely of steel, iron, brick, tile,
concrete, slate, glass or plasters, or any combination
thereof.
Materials that are reported as passing ASTM E 136,
Standard Test Method for Behavior of Materials in a
Vertical Tube Furnace at 750 °C shall be considered
non-combustible materials.
QUALIFIED
INSTALLER
See table
A
Mantel
Stand-off
B
16"
(406 mm)
10–12"
(254–305 mm)
38"
(965 mm)
21