Replacing Batteries; Using Handset Wall Holder - Valor H4 Series Installation & Owner's Manual

OWNER'S
INFORMATION

Replacing Batteries

WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic object
to remove the batteries from the battery holder or
the handset! This could cause a short circuit to the
receiver.
Low battery signal: see page 11.
BEFORE changing the batteries, turn off the valve
using the manual On/Off switch —see instructions on
page 7.
The appliance uses four 1.5 V AA alkaline batteries
for its remote control receiver battery holder and one
9 V alkaline battery for its handset. The batteries
should last one to two seasons, depending on usage.
Removing the batteries in the off -season will extend the
battery life. Should the batteries lose power, the control
may be operated by manually turning the control knob
at the valve or by turning off the valve at the switch.
To replace the batteries in the battery holder
1. The battery holder is located below the fi rebox,
usually on the right hand side (depending on your
installation). Remove the front trim. Grab the battery
holder and pull it out from its location.
Battery
holder
18
Servicing & Maintenance
2. Disconnect the battery holder from the cable.
3. Replace the batteries with 4 AA alkaline batteries.
4. Reconnect the cable.
5. Put the battery holder back in its position.
DO NOT LET the cable touch the underside of the
burner plate. It will melt during operation.
6. Reinstall the front trim.

Using Handset Wall Holder

Your fi replace equipment includes a wall
holder to store the handset. If it hasn't
been installed, refer to the instructions
further on in this manual for the
installation.
CAUTION