Table of Contents
Advertisement
INSTALLATION
WALL DRILLING AND BRACKET FIXING
As the first step, proceed with the following drawings:
● A vertical line up to the ceiling or up to the upper limit, at the center of the area in which the
hood is to be fitted.
● A horizontal line A at 980 – 1080 mm above the cooker top.
● A horizontal line B at X mm above the horizontal line A.
● A horizontal line C at 261 mm below the horizontal line A (solution 2).
Mark points:
● Mark a point (1) on the horizontal line A, 80 mm to the right of the vertical reference line.
● Repeat this operation on the other side and on the vertical reference line, checking that the
three marks are on one horizontal line.
● Mark a point (2) on the horizontal line B, 40 mm to the right of the vertical reference line.
● Repeat this operation on the other side, checking that the two marks are on one horizontal line.
● Mark a point (3) on the horizontal line C, 180 mm to the right of the vertical reference line
(solution 2).
● Repeat this operation on the other side , checking that the two marks are on one horizontal line.
Fix the brackets:
● Drill at the marked points (1), (2), (3) (solution 2), using a ɸ10 mm drill bit. Insert the wall plugs
11 into the holes (1), (2), (3) (solution 2).
● Fix the hood fixing bracket 20 with 3 screws 10 (5 x 50) at the horizontal line A. Fix the chimney
fixing bracket 21 with 2 screws 10 (5 x 50) at the horizontal line B.
Option
1
2
5
Chimney
X
400+0
/
400+300
390-620
Advertisement
Table of Contents
