Installation; Wall Drilling And Bracket Fixing - Midea MHT90BL Instructions Manual

INSTALLATION

WALL DRILLING AND BRACKET FIXING

As a first step, proceed with the following drawings:
l line up to the ceiling or up to the upper limit, at the center of the area in which the hood is

to be fitted.
A horizontal line A at 970 – 1070 mm above the cooker top.

A horizontal line B at a X mm above the horizontal line A.

A horizontal line C at a 288 mm below the horizontal line A (solution2).

Mark Points:
Mark a point (1) on the horizontal line A, 80 mm to the right of the vertical reference line.

Repeat this operation on the other side and on the vertical reference line, checking that the

three marks are leveled.
Mark a point (2) on the horizontal line B, 60 mm to the right of the vertical reference line.

Repeat this operation on the other side, checking that the two marks are on the same

horizontal line.
Mark a point (3) on the horizontal line C, 80 mm to the right of the vertical reference

line (solution2).
Repeat this operation on the other side , checking that the two marks are leveled.

Fix the brackets :
Drill at the marked points (1)、 (2)、 (3)(solution 2), using a ɸ10 mm drill bit.

Insert the Wall Plugs 11 into the holes (1)、 (2) 、(3)(solution2).

Fix the hood fixing bracket 20 with 3 screws 10 (5 x 50) at the horizontal line A.

Fix a Chimney fixing bracket 21 with 2 screws 10 (5 x 50) at the horizontal line C.

(3)
solution2
5
Option Chimney
1 400X400 155-500
2 500X500 255-700
3 600X600 355-900
X