Table of Contents
Advertisement
4. Installation
Settings to be made for this type of installation: Master boiler
Parameters
INSTALLATION
(1)
P.DHW:
(1)
CASCADE:
MASTER CONTROLLER
(1)
SYSTEM NETWORK
(1) The parameter is only displayed if INSTALLATION parameter is set to EXTENDED
Settings to be made for this type of installation: Follower boilers
Parameters
INSTALLATION
(1)
CASCADE:
MASTER CONTROLLER
(1)
SLAVE NUMBER
(1) The parameter is only displayed if INSTALLATION parameter is set to EXTENDED
52
Access
Settings to be made See chapter
Installer level
EXTENDED
#SYSTEM menu
Installer level
RV
#SYSTEM menu
Installer level
ON
#NETWORK menu
(1)
Installer level
ON
#NETWORK menu
Installer level
ADD SLAVE
#NETWORK menu
Access
Settings to be made See chapter
Installer level
EXTENDED
#SYSTEM menu
Installer level
ON
#NETWORK menu
Installer level
(1)
OFF
#NETWORK menu
Installer level
2, 3, ...
#NETWORK menu
Low loss header
R
Cascade outlet sensor
T
Connect the sensor to the terminal block S SYST on the
master boiler.
Cable BUS
Y
Connect the DHW sensor (Package AD212)
U
Install the expansion vessel on the heating return pipe
z.
¼ See chapter: "Connecting the expansion vessel",
page 22
¼ "Displaying the parameters in extended
mode", page 69
¼ "Setting the parameters specific to the
installation", page 70
¼ "Configuring the network", page 88
¼ "Displaying the parameters in extended
mode", page 69
¼ "Configuring the network", page 88
MCA 35
15/06/12 - 300022160-001-01
Advertisement
Table of Contents
