Removing The Keyboard - Clevo N170RD1 Service Manual

Disassembly

Removing the Keyboard

Figure 2
Keyboard Removal
1. Turn off the computer, turn it over to remove the battery
2. Remove screws
a. Remove the screws and
3. Remove screws
component bay cover.
4. Open it up with the LCD on a flat surface before pressing at point
b. Remove the screws.
cial eject stick to do this) while releasing the keyboard in the direction of the arrow
c. Eject the keyboard using
5. Carefully lift the keyboard
a special eject stick to
board ribbon cable
push the keyboard out
while releasing the key-
11
board as shown.
d. Lift the keyboard up and
disconnect the keyboard
a.
ribbon cable from the
1
locking collar socket.
b.

4. Component Bay Cover
9. Keyboard
• 5 Screws
2 - 6 Removing the Keyboard
- (screw size = M2.5x5L) and the component bay cover
1 3
- (screw size = M2.5x8L) to release the keyboard
5 6
up, being careful not to bend the keyboard ribbon cable
9
from the locking collar socket by using a flat-head screwdriver to pry the locking collar pins
10
away from the base (Figure 3c).
2
4
5
6
(page 2 - 5).
(Figure
to release the keyboard module (use the spe-
7
c.
3
8
d.
7
(Figure 3a).
4
3a).
as shown (Figure 3b).
8
. Disconnect the key-
10
7
9
10
11
11 11
10