Clevo N170RD1 Service Manual page 33

4. Lift the hard disk assembly
5. Remove screws - and separate the hard disk
9 11
6. Reverse the process to install a new hard disk (do not forget to insert the mylar cover between the bracket and
hard disk as shown before replacing the screws).
d.
c.
8
25
7
).
out of the bay (Figure 5c
7 8
from the bracket
12
10
13
14
9
12
New HDD's are blank. Before you begin make sure:
You have backed up any data you want to keep from your old HDD.
You have all the CD-ROMs and FDDs required to install your oper-
ating system and programs.
If you have access to the internet, download the latest application
and hardware driver updates for the operating system you plan to in-
stall. Copy these to a removable medium.
and mylar cover (Figure 5d
13 14

Installing 9.5mm or 7mm HDD
11
28
Note that the hard disks pictured on
these pages are all 9.5mm(h) hard disk
drive.
In some cases, a 7.0mm(h) hard disk
drive will be installed. Do pay attention
on the alignment of the hard disk and
bracket when tightening the screws.
For more information, contact your dis-
tributor/supplier, and bear in mind your
warranty terms.

HDD System Warning
Removing the Hard Disk Drive 2 - 9
Disassembly
Figure 5
) .
HDD Assembly
Removal (cont'd.)
c. Lift the HDD assembly
out of the bay.
d. Separate the HDD, my-
lar cover and bracket.

7. HDD Assembly
12. HDD
13. Bracket
14. Mylar Cover
• 3 Screws