Changing The Bucket; Fuses; Replacing Fuses; Fuse Capacities And Circuits - Kubota KX080-4 Operator's Manual

92 OTHER ADJUSTMENTS AND REPLACEMENTS
3. Avoid using rubber track on riverbeds, stony
underground, ferro-concrete and on iron plates. The
rubber can damage as well as increase wear on the
tracks.

CHANGING THE BUCKET

To avoid personal injury:
A There are two people required to replace the
bucket. One person operates the excavator,
and the other one mounts the bucket.
The person who mounts the bucket must
command-guide the movements of the front
end attachments. The operator should move
the front end attachments only according to the
commands of the person who mounts the
bucket. Continuous visibility between both
persons is indispensable. If there is no
visibility, stop working immediately.
A When replacing the bucket, make sure to wear
eye protection, a helmet and protective gloves.
A During attaching and detaching, chippings and
burns may occur at the bolts or bushings.
These may cause severe injuries.
A Never use your fingers for the alignment of the
components (linkage,
components may sever your fingers by
uncontrolled movements.
A Read the manual of the attachment to do a
correct operation
attachments are installed instead of Kubota
specified bucket.

FUSES

To avoid personal injury:
A When changing fuse, stop the engine and turn
the key in position "STOP". Keep the lock lever
for attachment control in the "LOCK" position.
bucket, arm). The
safely when other
BReplacing Fuses
1. Remove the cover of the fuse box.
2. Replace the burnt out fuse with a fuse having the same
capacity.
(1) Fuse box
BFuse Capacities and Circuits
1 A/C Controller (+B)
2 Meter (+B)
3 Blower Motor
4 Relay
5 ECU (AC)
6 Room Light
7 Starter
8 Wiper / Washer
9 Compressor
10 Electrical Outlet
11 Front Work Light
12 Cab Work Light
13 Radio (AC)
14 Fuel Filter Heater
15 ECU (+B)
16 ECU (POWER)
17 Beacon
18 Horn Switch
19 Horn
20 Lever Lock
21 Alternator
22 Fuel Pump