Table of Contents
Advertisement
26
OPERATION OF THE ENGINE
4. Set the starter key to the "RUN" position. Hold the key
at this position until the "
disappears.
(1) Starter switch
5. Now make sure the "
onscreen. If not, the system has malfunctioned.
Contact your local dealer for repairs.
6. Turn the key to the position "START" and release
after the engine has started.
7. Check if all warning lamps have gone out. Should a
warning lamp still be lit up, stop the engine then
remove the key and check for the cause.
A The starter motor draws a large current. Avoid running
it longer than 10 seconds continuously.
If the engine fails to start within 10 seconds, set the
key to the "STOP" position, wait for 20 seconds or
longer, and repeat the above steps 5 thru 7.
A If the battery is dead and must be connected to
another battery with jumper cable, be sure to use a
12V battery. Never use a 24V batteries.
" mark on the display panel
(A) "STOP"
(B) "RUN"
(C) "START"
" and "
" marks appear
A If you keep the pilot control lock lever at "UNLOCK"
and try to start the engine, "Up Lever Lock" appears
on the meter panel and the engine cannot be started.
Before staring the engine, make sure the pilot control
lock lever is set at the "LOCK" position.
A When the engine starts, the meter may momentarily
turn off and a beep may sound. This is not a problem.
[For KCL only]
A This machine is equipped with an anti-theft device. If
you try to get the engine started with the wrong key,
"Wrong key""Unable to start" appears on the meter
panel and the engine cannot be started. Use the
specified key.
A Even the correct key, if attached to something metallic
(key ring, for example), may fail to start the engine. In
such case, remove the metallic attachment and insert
the key in the key switch.
Advertisement
Table of Contents
