Changing The Bucket; Fuses; Replacing Fuses; Fuse Capacities And Circuits - Kubota Super Series 2 KX 91-3 Operator's Manual

C To loosen the tracks, follow following procedure:
To avoid personal injury:
A Do not loosen the grease nipple completely or
too quickly. Otherwise grease under high
pressure in the tension cylinder could squirt
out.
A Make sure that no obstacles, such as stones
are caught in the track. Remove such obstacles
before adjusting the track tension.
1. Loosen the bolt of the cover and remove the cover.
2. Using a socket wrench, loosen the grease nipple a few
turns.
3. When grease oozes out from the thread, rotate the
track and loosen the track in the lifted position (see
illustration).
After adjustment is completed:
Using the socket wrench, tighten the grease nipple.
Tightening torque must be between 1000 to 1100 kgf-cm.
A If the tracks are too tight, wear is increased.
A If the tracks are too loose, the track pads may collide
with the sprocket, wear is increased.
The track may dislocate or come off.
A Clean the track after every use.
A Should the track tension be high due to sticking mud,
lift the track with the help of the boom, arm and bucket,
idle the engine and remove mud from the track,
especially from the openings of the link plate carefully.
OTHER ADJUSTMENTS AND REPLACEMENTS

CHANGING THE BUCKET

To avoid personal injury:
A When the coupling pins are removed or
installed, chips may come off. Always use
gloves, goggles and a helmet.
A When the change of the equipment must be
performed with the engine running, always
work as a 2-person team.
One person sits in the operator's seat and the
other works on the machine.
A Do not use your fingers to center the holes,
since they may be injured or even cut in case of
sudden or uncontrolled movements.
A Read the manual of the attachment to do a
correct
attachments are installed instead of Kubota
specified bucket.

FUSES

To avoid personal injury:
A When changing fuse, stop the engine and turn
the key in position "STOP".
BReplacing Fuses
1. Remove the cover of the fuse box.
2. Replace the burnt out fuse with a fuse having the same
capacity.
BFuse Capacities and Circuits
5A Room Light
20A Work Light
5A Meter Sub
15A Cigarette Lighter
15A Auxiliary
15A Wiper / Washer
operation safely when
10A Heater Fan
15A AI Motor
10A Alternator
5A Lock Lever
10A Horn
10A Meter Main
5A Travel Hi-Low
5A Relay Source
63
other