Table of Contents
Advertisement
Understanding the printer menus
Hole Punch
Off
On
Hole Punch Mode
2 holes
3 holes
4 holes
Duplex Binding
Long edge
Short edge
Paper Saver Orientation
Auto
Landscape
Portrait
Paper Saver
Off
2‑Up
3‑Up
4‑Up
6‑Up
9‑Up
12‑Up
16‑Up
Paper Saver Border
None
Solid
Paper Saver Ordering
Horizontal
Reverse Horizontal
Reverse Vertical
Vertical
Specify whether prints have punched holes.
Notes:
•
Off is the factory default setting.
•
This menu item appears only when a supported staple, hole punch finisher is installed.
Specify the number of holes to be made on the prints.
Notes:
•
3 holes is the U.S. factory default setting. 4 holes is the international factory default
setting.
•
This menu item appears only when a supported staple, hole punch finisher is installed.
Define binding for two-sided pages in relation to the page orientation of the printed document.
Notes:
•
Long edge assumes binding along the long edge of the page (left edge for portrait and top
edge for landscape).
•
Short edge assumes binding along the short edge of the page (top edge for portrait and
left edge for landscape).
Specify the orientation of a multiple‑page document.
Note: Auto is the factory default setting. The printer chooses between portrait and landscape.
Specify that multiple‑page images be printed on one side of a paper.
Notes:
•
Off is the factory default setting.
•
The number selected is the number of page images that are printed per side.
Print a border on each page image.
Note: None is the factory default setting.
Specify the positioning of multiple‑page images.
Notes:
•
Horizontal is the factory default setting.
•
Positioning depends on the number of page images and whether they are in portrait or
landscape orientation.
183
Advertisement
Table of Contents
