CrimeStopper Super Rage CS-2011RS Installation Instructions Manual page 8

WIRING: 4-PIN Shock Sensor (22 Gauge wires)
4 Pin Plug - Sensor Plug 22 Gauge -:
White Wire - Negative Trigger
Blue Wire - Negative Warn Away
Black Wire - Sensor Ground
Red Wire - Sensor +12Volt Power
Sensor Adjustment
Adjust the main shock sensor with the small black dial. Clockwise will increase sensitivity and counter-
clockwise will decrease sensitivity. Adjust Pre-Warning level with small White dial.
WIRING: 3-PIN Harness - Door Locks (22 gauge wires)
GREEN: (-) Negative pulse for LOCK
BLUE: (-) Negative pulse for UNLOCK
RED: +12V Coil Power for external relays TERM 86.
NEGATIVE TRIGGER DOORLOCK WIRING
GREEN
RED
BLUE
L
UL
The sensor supplied with this system requires no
additional wiring. Simply mount the sensor in a suitable
location and plug it in. Adjust sensitivity as necessary.
FACTORY
L
POWER
LOCKING
UL
RELAYS
NOTE: A Low-cost CS-6500DLI inverter
module is available to convert Negative
CS2011RS lock/unlock signals for
Positive systems.
POSITIVE TRIGGER DOORLOCK WIRING
GREEN
RED
BLUE
85 86
87
30
87A
FUSED
+12V
+
85 86
87
87A 30
FACTORY
POWER
LOCKING
RELAYS