CrimeStopper Super Rage CS-2011RS Installation Instructions Manual page 4

Green: (-) Start Activation Trigger
This wire allows an additional source or accessory to activate a Remote Start. A 1-second Ground
pulse on this wire will trigger a remote start. This wire must be used with the RS400 CoolTimer
Temperature / Timed Start Accessory (Not included).
Brown: (+) Siren Output
Connect brown wire to siren red wire. Connect black wire of siren to chassis ground (body metal).
Brown/White: (-) Horn Honk Output (Optional, may require relay)
This wire allow the alarm system to honk the vehicles factory horn or air horns. May require a relay depending
on the type of horn activation circuit in the vehicle.
Black/White: (-) Dome Light Illumination Output (Optional, may require relay)
This wire allows the alarm system to turn on the vehicles dome light when disarming the alarm system. May
require a relay depending on the type of dome light circuit in the vehicle.
Green/Red: Remote Aux. Output 1 or MAP-Mobile Accessories Protection (Optional, requires relay)
This is a programmable output that can operate two different ways: 1. (DEFAULT) Remote Auxiliary Output 1
provides a ½ Second (-) Negative pulse when Button #3 is pressed and released or it can function as an MAP
output that provides a continuous (-) Negative output when in VALET PARK MODE. M.A.P. can be used to
interrupt power/accessory wiring to prevent unauthorized access of the vehicle's audio or entertainment
systems when Valet Park mode is ON. See Diagram Below.
GREEN/RED
M.A.P. OUTPUT
OFF
ACC
IGN
START
WIRING: 9-PIN Harness (22 Gauge wires)
85 86
IGN.
87
SWITCHED
87A 30
C U T
+
MOBILE ACCESSORY PROTECTION
Connect relay as shown to interrupt the power
wire of mobile accessories such as Audio system
or Cellular telephone. The Alarm will disconnect
these accessories when in VALET PARK MODE.
F M
105. 5
RADIO