CrimeStopper Super Rage CS-2011RS Installation Instructions Manual page 14

PROGRAMMABLE OPTIONS
3. DOUBLE UNLOCK PULSE
With this option ON, the unit will send 2 unlock pulses when the system is disarmed. This feature may be required for
interfacing this alarm with some existing Factory Unlock systems. Factory Default setting is OFF.
4. TACH LEARNING
This option has no values or default settings. See Tach Reference Programming Section.
5. REMOTE START ENGINE RUN TIME
Set engine run time for remote start for 12, 24, 36 or 48 minutes as needed. Factory Default setting is 24 min.
6. OPTION RESET – RESTORE ALL DEFAULT VALUES
Pressing button #2 at this option will restore all Factory Default option values/Settings.
7. PASSIVE ARMING
With this option ON, the unit will arm itself 30 Seconds after the ignition is turned off and the last door has been closed.
Lights will flash twice when last door is closed indicating passive countdown. If a door is reopened, the system will
wait and begin countdown again when closed. Factory default setting is ON.
8. ACTIVE RE-ARM
Active Re-arming allows the system to re-arm itself 30 seconds after disarmed with the transmitter if a door has not
been opened. This is handy if the vehicle is accidentally disarmed without your knowledge. Default setting is OFF.
9. PASSIVE LOCKS
This option controls whether the doors will lock when Passive Arming occurs. Note: This may increase the risk of
locking keys in the vehicle. Factory default setting is OFF.
10. PARKING LIGHTS ON WITH DISARM
Keeps parking lights on when system is disarmed to assist in locating your vehicle. Default setting is OFF.
11. GREEN/RED WIRE: TRUNK POP (AUX 1) or M.A.P. OUTPUT
This option controls whether the system's GREEN/RED wire is used for Remote Output 1 or as an Output for Mobile
Accessories Protection that activates when in Valet Park Mode. Factory setting is for Trunk Pop.
12. PINK WIRE: CAR JACK TRIGGER or GLOW PLUG INPUT
This option controls whether the system's PINK wire is used as a +12V Carjack trigger wire or as a Glow Plug input
wire for Diesel Engines. Factory setting is for +12V Glow Plug input.