CrimeStopper Super Rage CS-2011RS Installation Instructions Manual page 5

Blue/Black: (-) Remote Aux. Output 2 (Optional, may require relay)
This wire provides a Momentary<-> Negative output when Button #3 (Trunk) is pressed and held for more
than 2 seconds. Output stays on as long a remote button is held down.
Blue/White: (-) Passenger Door Unlock Output (Optional)
This wire activates when the unlock button on the remote is pressed a second time when upon disarming.
Connects to unlock circuit for passenger door or doors when using separate driver's door unlock configuration.
See DOOR LOCK WIRING for configuration options.
Orange: (-) Negative Starter Disable Output (optional)
This wire should be connected to the Yellow wire of the pre-wired relay socket for the starter disable. Connect
the blue wire of the relay socket to the Ignition switched wire on the vehicle. Cut the vehicle starter wire and
connect each half to an Orange wire on the relay socket. See Diagram Below.
CONNECT TO
ORANGE WIRE
OF ALARM
PRE-WIRED
STARTER DISABLE
RELAY & SOCKET
START OUTPUT
FROM ALARM
6-PIN HARNESS
Orange/Black: (-) OEM Disarm Output
This wire provides a Ground pulse to disarm vehicles' Factory anti-theft system prior to a Remote Start.
Connect this wire to the vehicles' anti-theft disarm wire. This wire is sometimes found coming off the Driver's
door key switch or at the Factory Anti-theft control module.
WIRING: 9-PIN Harness (22 Gauge wires)
IGN. SWITCHED
STARTER WIRE
YELLOW
BLUE
BROWN
CUT
ORANGE
ORANGE
IGNITION SWITCHED
"ON" & HOT THROUGH
CRANKING
STARTER
MAKE CERTAIN TO
CONNECT BROWN
WIRE TO STARTER
MOTOR SIDE.