CrimeStopper Super Rage CS-2011RS Installation Instructions Manual page 6

WIRING: 4-PIN Harness (18/22 gauge wires)
Red/White: Tachometer Input
When installing the CS2011RS in TACH REFERENCE mode, this wire must be connected to a valid source of
AC voltage. This wire allows the unit to sense the engine and control the starter motor.
Black: Chassis Ground
Connect to body metal of the vehicle using a sheet metal screw and a star washer.
Yellow/White: (-) Accessory Output (For Adding Accessory or IGN2 Relays)
Yellow: (-) Ignition 1 Output (For Adding Ignition Relays)
Use these wires when the vehicle requires a second IGNITION 1, IGNITION 2, or ACCESSORY wire to be
activated. This occurs commonly in Toyota, and late model GM cars. See diagram below.
YELLOW
OR
(YELLOW/WHITE)
85
86
-
+
30 87
BATTERY
2nd IGN 1
OR
(2nd IGN2 /ACC WITH YEL/WHT)
WIRING: 5-PIN Harness (22 gauge wires)
Violet: (+) Door Pin Switch Input
Connect to door switches that read +12 volts when door is opened. A (+) positive door switch wire will read (-)
ground when doors are closed.
Green: (-) Door Pin Switch Input
Connect to door switches that read ground when door is opened. A (-) negative door switch wire will read +12
volts when doors are closed.
Blue: (-) Hood/Trunk Pin Switch Input
Connect to pin switches that read ground when hood and trunk are opened. It may be necessary to install your
own switches. The kit includes a 6" brown wire end for connecting to the supplied hood pin switch terminal.