CrimeStopper Super Rage CS-2011RS Installation Instructions Manual page 7

Pink: (+12V) Diesel Glow Plug Input or Car Jack Input (Programmable Input Wire)
Glow Plug (Diesel):
Connect to the indicator circuit that shows +12 volts while the "WAIT TO START LAMP" is on. When
this wire is used, the CS2011RS will wait until light turns off before attempting a remote start. Note: An
inverter module or relay can be used for vehicles that have a Negative Wait to Start lamp circuit.
Carjack Trigger
When using Carjack protection, connect this Pink wire to a toggle switch, or positive door trigger or
ignition depending on your level of Carjack protection. When +12V is applied to this wire with IGN on
and a door is opened then closed, a Carjack countdown will begin. See Diagram Below for optional
wiring configurations.
HIDDEN BUTTON or
TOGGLE SWITCH
(Not Included)
PINK
CONTROLLED W/SWITCH
White: (+12V) Brake Reset
Connect the Purple wire to the side of brake pedal switch that shows +12 volts ONLY when pedal is
depressed. This will turn off the remote start if someone attempts to drive the car without the keys or if the
Ignition key is not turned on all the way.
WIRING: 2-PIN LED / 2-PIN Program-Valet Button (22 gauge wires)
Mount LED in a visible location in the Dash or Console. Connect the small 2-pin plug from the LED to the
control module. Note: Connectors are designed so that they will only plug into their appropriate slots.
Mount the Valet/Program/Override button in a suitable location. Connect the 2-pin plug from the Switch to the
control module. Note: Connectors are designed so that they will only plug into their appropriate slots.
WIRING: 5-PIN Harness (22 gauge wires)
OPTIONAL CAR JACK WIRING:
12 V
+
IGN SW
+ IGN
PINK
FULL-TIME CARJACK