CrimeStopper Super Rage CS-2011RS Installation Instructions Manual page 11

SMART TACHLESS JUMPERS: (Remove Access Door on top of module)
The purpose of the jumpers is to reduce the starter cranking time [if needed] when in "Smart Tachless" mode only.
To shorten the crank time by one percent remove jumper #P2. Test the unit and see if the decrease is correct. If a
shorter crank time is still required, then remove Jumper #1, which will reduce the cranking time by another percent.
Test the unit and see if the decrease is correct. These are the only two "Smart Tachless" adjustments.
IMPORTANT SMART TACHLESS NOTES:
NOTE (1): Smart Tachless Mode is NOT guaranteed to work on EVERY vehicle. Occasionally older vehicles,
Dual-Battery Systems, or Out-of-Tune vehicles will not operate properly in Smart Tachless Mode. Use a Tach
wire if problems occur with Smart Tachless Mode
NOTE (2): If you have connected the RED power lines before performing steps for "Setting Up the Smart Tachless
Mode", the CS2011RS will not have the correct voltage reference for your vehicle. If this is the case, power down the
unit and perform those steps.
NOTE (3): If you have changed battery in the vehicle, wait 2 hours before attempting a remote start or follow
the set up steps again.
The CS2011RS includes a Tach Reference Mode that provides reliable starting performance though engine speed
sensing. The WHITE/RED wire is used for Tach signal input. Most modern engines include various points where the
Engine Speed [Tach] signal may be obtained.
Distributor or Ignition Control Module, Coil Pack, Engine Computer, or Crankshaft Sensor. Sometimes Fuel injection
solenoids, and Alternator stator pins can be used. These Tach Signal locations mentioned are provided as a
guide, your vehicle may differ. Some locations will NOT be a good location for Tach source due to RF noise or
Computer Data. If you cannot locate a good tach signal, then call Crimestopper for Tech Support.
TACH REFERENCE PROGRAMMING:
1. Open hood (Blue wire must be grounded).
2. Connect WHITE/RED wire to a valid Tach source.
3. Start engine with key.
4. Press program button 5 times, then wait for 5 light flashes.
5. Wait at least one second then push program button slowly (4) times, you should get a light flash after each
button press. This unit is now at option #4-Tach Learning.
6. Press Button #1 on remote transmitter. The unit will read the Tach source and flash the lights twice for
program confirmation.
7. If lights do not flash twice for confirmation, then try another tach source and repeat Steps 1-6 above.
SMART TACHLESS MODE cont.
TACH REFERENCE MODE
Tach Signal examples: Negative (-) side of ignition coil, at the