Oce cm6520 User Manual page 45

3
Reminder
When turning the power off, then on again, wait at least 10 seconds before turning the power on again;
otherwise, this machine may not function properly.
!
Detail
Although the method for entering a static IP address without using the DHCP server is described in the
procedure here, it is also possible to automatically assign the IP address from the DHCP server. When
"IP Application Method" is specified as "Auto Input" and "DHCP Settings" is set to "ON" in the setting
screen that is displayed, the IP address, subnet mask, and gateway address settings are automatically
assigned from the DHCP server on the network, so it is not necessary to assign them manually.
However, note the following when setting "DHCP Settings" to "ON".
Check with the network administrator that the DHCP server exists. If the DHCP server does not exist,
be sure to specify settings for "IP Address", "Subnet Mask", and "Default Gateway".
If the settings for the IP address and other items have been assigned using the DHCP server, there is
a possibility that they may be automatically changed. When the settings for the IP address and other
items are changed, if the IP address has been used to specify a printer on the network for printing, there
is a possibility that printing may not be possible because this machine cannot communicate with the
network. If "DHCP Settings" has been set to "ON", it is recommended that the IP address assigned to
this machine be fixed in the DHCP server settings.
3-4
Setting up network printing
cm6520