Install A Comfort Wired Handset; Connect The Device; First Start-Up - Alcatel-Lucent ALE-30h User Manual

User Manual

Install a comfort wired handset

Your phone is provided with a connected handset.
If you have to replace it:
•
Plug-in the wired handset to the appropriate connector
(see chapter: Description of the connectors.).
•
Make sure you position the cable correctly in the
compartment intended for that purpose.

Connect the device

Please read safety instructions first.
Connect the handset if it is not connected (your phone is usually provided with the handset
connected).
Connect the keyboard to the RJ9 connector of the phone (ALE-10 Keyboard - optional - sold
separately). The magnetic alphabetic keyboard is only available for ALE-30h Essential
DeskPhone.
The ALE-30h and ALE-20h Essential DeskPhone can be connected to an IP network or a
Digital network. Connect the keyboard to the RJ9 connector of the phone the desk phone to
the IP line or Digital line (UA) thru RJ45 connector. The desk phone starts automatically in IP
mode or Digital (UA) mode regarding the connected network.
If your desk phone is not powered by PoE (Power over Ethernet) or PoDL (Power over
Digital Line), you have to plug the USB-C power adapter (sold separately).
In Digital mode, the local USB-C Power Adapter is mandatory when plugging an expansion
module.
The power adapter is sold separately. For more information, contact your installer or
administrator.
For more details, please consult the section: Description of the connectors.

First start-up

The desk phone starts in IP mode (IP network) or Digital mode (UA) according to the connected network.
If your desk phone detects a UA line, it stays in low power mode (the top LED is purple blinking) until boot
is granted by the system. If the phone stays in low power mode, you have to plug a power adapter.
8AL91433ENAAed01 9 /70