Table of Contents
Advertisement
User Manual
'Meet me' conference
The 'Meet me' function is used to set up a conference with a maximum of 29 persons (maximum value is
configured in OXE system, it can be 7, 15 or 29).
2.29.1.1 Initiate a 'Meet me' conference
In order for the participants to join the conference, you must first decide on a meeting time for the
conference and send them the access code.
•
Enter the 'Meet me' conference prefix. it is defined by the administrator during system configuration.
If necessary you may need to contact your administrator.
•
Enter the conference access code.
The conference is set-up. Participants must enter this access code to join the conference call. Send the
conference call access code to the participants.
In case of network connected OXE systems, to initiate a 'Meet me' conference with a distant OXE system,
you have to enter a phone number of distant OXE system after prefix, to locate the conference. For more
information, contact you administrator.
2.29.1.2 Join a 'Meet me' conference
Once set-up by the conference initiator, other participants can join the 'Meet me' conference.
•
Enter the joining code for the 'Meet me' conference. This code is defined by the administrator during
system configuration. If necessary you may need to contact your administrator.
•
Enter the conference access code.
Conference access code: 'x' digits code defined by the conference master and communicated to the
participants so that they can join the conference.
•
You are in conference mode.
An audible beep rings when a participant joins the conference.
You cannot join a conference if there are already the maximum number of participants.
If you cannot directly reach the conference, you have to call first an internal user or an Attendant Set. This
one dials the call number for joining the 'Meet-me ' conference and then transfers your call (10 seconds).
Intrusion into an internal conversation (barge-in)
Your contact's line is busy. If the number is not 'protected' and if authorised, you can intrude into the call:
•
Intrusion
2.30.1.1 Protect a call against intrusion
•
Press programmed key. The programmed key has to be configured by the system:
intrud) (by default).
•
Enter contact's number.
Protection is cancelled when you hang up.
Signal malicious calls
This key lets you signal a malicious call. If this call has an internal source, it is signalled to the system by a
special message.
•
You receive a malicious call.
•
Malicious
8AL91433ENAAed01
No intrusion (No
31 /70
Hide quick links:
Advertisement
Table of Contents
