Connecting The Power Cord, Printer And Barcode Scanner - Barkey plasmatherm Instructions For Use Manual

Operation
4.1.2

Connecting the power cord, printer and barcode scanner

Optional peripheral devices such as a log printer or a barcode scanner can be connected to
the Barkey plasmatherm. If you wish to use such devices, we recommend that you also
connect their cables when the power cord of the Barkey plasmatherm is connected to the
device.
CAUTION
The Barkey plasmatherm may only be operated with the following two peripheral
devices:
EPSON TM-U220B-007 needle printer
Honeywell CCD barcode scanner 3800g
These two devices together with their user documentation are available as accesso-
ries from Barkey GmbH & Co. KG. The use of other devices is not permitted.
If an optional peripheral device is connected to the Barkey plasmatherm for the first time,
the appropriate signal connection for the peripheral device must be activated before it can
be used. Details are described in a separate service description which can be requested
from Barkey GmbH & Co. KG.
The device's termination panel is located on the underside (front left). The panel provides:
230/115 VAC
50-60 Hz
X2
Figure 3: Terminal panel sticker
►
Lift the device at the front or left to gain access to the sockets.
►
Connect the supplied mains power cord with its plug for non-heating appliances to
the non-heating appliance socket. The cord runs towards the back of the device.
F1
T8A
F2
T8A
X1
Earth
terminal
a mains power socket (230/115 VAC
50-60 Hz / for non-heating appli-
ances)
a socket (X2) for optional connection
of a log printer
a socket (X1) for optional connection
of a barcode scanner
two mains fuses (F1 and F2, screw-in
fuse holders)
earth terminal
a sticker with the labels the sockets in
the termination panel