Barkey plasmatherm Instructions For Use Manual page 54

Figure 37: Opening the drain cock
►
Lift the heating cushions slightly and ensure that they drain completely.
►
Hold the device firmly and tilt it gently forward until it is completely empty.
►
Now close the drain cock, push the drain tube back into its recess in the base of the
device so that it is retained by the studs located on either side, and push the device
back so that it is standing fully on its base.
5.3.2 Filling with water
►
If you are not filling the device from empty but just topping it up:
Unscrew the plug from the filler opening as described in the Chapter Draining off the
water.
►
When filling the device from empty, switch the device on with the On/Off button.
It will now display a message asking you to fill with water.
►
To fill with water, select the fill level display described in the Chapter Fill level dis-
play from the menu.
►
Place two micropur tablets in the filler opening.
CAUTION
Always add two micropur tablets to the distilled or de-mineralised water.
For devices supplied new or exchange devices, or following maintenance and re-
pairs, the two micropur tablets are always already inside the tank for the heat trans-
fer fluid.
Cleaning and care
►
Open the drain cock by turning it
anticlockwise (90º). Allow the heat
transfer liquid to drain off.