Barkey plasmatherm Instructions For Use Manual page 24

CAUTION
Only use the power cord supplied. It is fitted with a non-heating appliance angle-
entry plug and is matched to the device's operating voltage.
CAUTION
Cords may only be connected to the optional accessories, the printer or the barcode
scanner when the Barkey plasmatherm has been turned off and the printer has been
turned off.
►
Connect the cable supplied with the printer with its smaller plug to socket X2. (This
plug does not fit socket X1.) Using a suitable screwdriver, secure the plug in position
with its two captive screws.
CAUTION
Only use the cable supplied to connect the printer.
►
Connect the other end to the printer. Using a suitable screwdriver, secure the plug in
position with its two captive screws.
►
Connect the barcode scanner cord to socket X1. (This plug does not fit socket X2.)
Using a suitable screwdriver, secure the plug in position with its two captive screws.
►
Connect the printer to the mains using the cord supplied, and then switch the printer
on.
NOTE
Do not forget to activate the device connections of the peripherals you are using
when connecting peripherals to the Barkey plasmatherm for the first time. Details
are described in a separate service instruction which can be requested from Barkey
GmbH & Co. KG.
Operation