Barkey plasmatherm Instructions For Use Manual page 37

Operation
When a program has been started, the connection between the device and a connected log
printer is verified if a printer has been configured in the service menu. If the printer is not
connected, or if it is switched off or has a fault, the user is made aware of this by a flash-
ing icon ("
to the printer while the current program is in progress, but this will not affect the actual
heating operation.
P L A S MA
R e m a i n in g t im e 1 0 :3 1
- S t o p
Figure 17: Printer message
Whatever the status of the printer connection after the program starts, there is no further
check on the printer during the ongoing program.
When a program has been started, the connection to an IT network is also verified if this
has been configured in the service menu. If the Barkey plasmatherm is not connected to
the network, or if the network connection is faulty or the remote terminal is not ready or
has a fault, the user is made aware of this by a flashing icon ("
of the screen. If this happens, no further data is sent to the IT network while the current
program is in progress.
P L A S MA
R e m a i n in g t im e 1 0 :3 1
- S t o p
Figure 18: IT message
Whatever the status of the IT connection after program start, there is no further check on
the connection during the ongoing program, but this does not affect the actual heating op-
eration.
") in the top left corner of the screen. If this happens, no further data is sent
+
+
►
Connect the printer up to the Barkey
plasmatherm and check that it is oper-
ating correctly.
►
If necessary, cancel the program and
start it again for correct logging.
") in the top left corner
►
If necessary, connect the Barkey
plasmatherm to the network and en-
sure that the remote terminal is ready
for operation and fault-free.
►
If necessary, cancel the program and
start it again for correct logging.