Switching On If The Fill Level Is Too Low - Barkey plasmatherm Instructions For Use Manual

►
If a log printer is connected to the Barkey plasmatherm and the corresponding device
connection is activated, switch the printer on as well.
The Barkey plasmatherm is now ready for operation.
NOTE
The device can be switched off at any time by pressing the top button on the oper-
ating panel.
4.1.4

Switching on if the fill level is too low

If the fill level in the Barkey plasmatherm is too low when it is switched on, the menu for
filling the tanks is shown first after the initial screen. The prompt "Fill Tank" is addition-
ally highlighted by flashing.
NOTE
You cannot quit this menu until a certain level is reached in the tank or the device
is switched off again.
F i l l l ev e l
E m p t y cu s h i on s
c o m p l e te l y !
F I L L t an k !
Figure 6: Low fill level,
"FILL Tank" prompt
When the tank is filled and the required
level has been reached, the "FILL Tank"
prompt is replaced by the information
"Tank is FULL" which also flashes. An
intermittent acoustic signal also sounds.
Operation