Consumables; Hydraulic Oil - PRONAR T700 Operator's Manual

SECTION 5
and lubricating properties, it is recommended to apply on outer leaf spring surfaces very thin
layer of lithium or lime alkali grease. For this purpose, silicone spray (for lubricating of guides,
lock etc. see table) can be used. Sliding surfaces shock absorber and shock absorber pin
should be lubricated according to recommendations contained in table (5.4).
Parts, which should be lubricated with machine oil, should be wiped with dry cleaning cloth
and then a small quantity of oil should be applied do surfaces (with oil can or brush). Wipe off
excess oil.
Change of grease in hub bearings should be entrusted to specialised service points,
equipped with the appropriate tools. According to the recommendations of the axle
Manufacturer, dismantle the entire hub, remove the bearing and individual sealing rings. After
careful washing and inspection mount lubricated elements. If necessary, bearing and seals
should be replaced with new parts. Lubrication of axle bearings shall be performed at least
once in 2 years or every 50,000 km. In the event of intensive use, lubrication should be
performed more frequently.
Empty grease or oil containers should be disposed of according to the recommendations of
the lubricant Manufacturer.
ATTENTION!
Lubricate all lubrication points after the first month of use.
After finishing washing wait until trailer is dry and then grease all inspection points
according to recommendations. Remove excess oil or grease with a dry cloth.
During trailer use the user is obliged to observe lubrication instructions according to
attached lubrication schedule.

5.7 CONSUMABLES

5.7.1 HYDRAULIC OIL

Always adhere to the principle that the oil in the trailer hydraulic system and in the tractor
hydraulic system are of the same type. In the event of application of different types of oil
make certain that both hydraulic substances may be mixed together. Application of different
5.33
Pronar T700