Table of Contents
Advertisement
Installing the switch in a 19-inch rack
Installation requirements
Table 3 Installation requirements for the S6520XE-HI switches
Installation
method
Using the front
and rear
mounting
brackets
Figure 2 Rack-mounting procedure by using the front and rear mounting brackets
NOTE:
If a rack shelf is available, you can put the switch on the rack shelf, slide the switch to an appropriate
location, and attach the switch to the rack by using the mounting brackets.
Installation accessories
The switch is provided with front mounting brackets with M4 screws (see
brackets with shoulder screws (see
Figure 3 Front mounting bracket
1
(1) Hole for attaching the bracket to the switch
(3) M4 screw
Installation requirements
•
Install the front mounting brackets at the power module
side or port side.
•
Install the rear mounting brackets as required by the rack
depth:
If the rack depth is in the range of 328 to 494 mm
(12.91 to 19.45 in), orient the bracket arm forward.
If the rack depth is in the range of 172 to 338 mm (6.77
to 13.31 in) and the distance from the rear rack posts to
the inner surface of the cabinet door is longer than 153
mm (6.02 in), orient the bracket arm backward.
Figure
2
3
4), and a grounding cable.
(2) Hole for attaching the bracket to a rack post
5
Installation
procedure
See
"Rack-mounting by
using the front and rear
mounting
brackets."
Figure
3), rear mounting
Advertisement
Table of Contents
