Connecting The Micro Usb Console Cable - H3C S6520XE-HI Series Installation Manual

RJ-45
4
5
6
7
8
To connect a terminal (for example, a PC) to the switch through the serial console cable:
Plug the DB-9 female connector of the serial console cable to the serial port of the PC.
1.
Connect the RJ-45 connector to the serial console port of the switch.
2.
NOTE:
• Identify the mark on the serial console port and make sure you are connecting to the correct port.
• The serial ports on PCs do not support hot swapping. To connect a PC to a powered-off switch,
first connect the PC end. To disconnect a PC from a powered-off switch, first disconnect the
switch end.

Connecting the micro USB console cable

Connect the standard USB connector to the USB port of the configuration terminal.
1.
Connect the micro USB connector to the micro USB console port of the switch.
2.
Click the following link, or copy it to the address bar on a browser to log in to the download page
3.
of the USB console driver, and download the driver.
http://www.h3c.com/en/support/resource_center/hk/other_product/usb_console/usb_console/
?tbox=Software
Select a driver program according to the operating system you use:
4.
XR21V1410_XR21B1411_Windows_Ver1840_x86_Installer.EXE—32-bit operating
system.
XR21V1410_XR21B1411_Windows_Ver1840_x64_Installer.EXE—64-bit operating
system.
Click Next on the installation wizard.
5.
Signal
SG
SG
RXD
DSR
CTS
20
DB-9
5
5
3
4
7
Signal
SG
SG
TXD
DTR
RTS