Table of Contents
Advertisement
132
3-2. Opening, closing and locking the doors
If the door handle becomes wet while the electronic key is within the effec-
●
tive range, the door may lock and unlock repeatedly. In that case, follow the
following correction procedures to wash the vehicle:
• Place the electronic key in a location 2 m (6 ft.) or more away from the
vehicle. (Take care to ensure that the key is not stolen.)
• Set the electronic key to battery-saving mode to disable the smart entry &
start system. (P. 130)
If the electronic key is inside the vehicle and a door handle becomes wet
●
during a car wash, a message may be shown on the multi-information dis-
play and a buzzer will sound outside the vehicle. To turn off the alarm, lock
all the doors.
The lock sensor may not work properly if it comes into contact with ice,
●
snow, mud, etc. Clean the lock sensor and attempt to operate it again, or
use the lock sensor on the lower part of the door handle.
A sudden approach to the effective range or door handle may prevent the
●
doors from being unlocked. In this case, return the door handle to the origi-
nal position and check that the doors unlock before pulling the door handle
again.
If there is another electronic key in the detection area, it may take slightly
●
longer to unlock the doors after the door handle is gripped.
When the vehicle is not driven for extended periods
■
To prevent theft of the vehicle, do not leave the electronic key within 2 m
●
(6 ft.) of the vehicle.
The smart entry & start system can be deactivated in advance. (P. 437)
●
To operate the system properly
■
Make sure to carry the electronic key when operating the system. Do not get
the electronic key too close to the vehicle when operating the system from the
outside of the vehicle.
Depending on the position and holding condition of the electronic key, the key
may not be detected correctly and the system may not operate properly. (The
alarm may go off accidentally, or the door lock prevention may not operate.)
If the smart entry & start system does not operate properly
■
Locking and unlocking the doors: Use the mechanical key. (P. 413)
●
Starting the hybrid system: P. 413
●
Customization
■
Settings (e.g. smart entry & start system) can be changed.
(Customizable features: P. 437)
If the smart entry & start system has been deactivated in a customized
■
setting
Unlocking and locking the doors:
●
Use the wireless remote control or mechanical key. (P. 118, 413)
Starting the hybrid system and changing power switch modes: P. 413
●
Stopping the hybrid system: P. 174
●
Advertisement
Table of Contents
