Cisco NCS1004 Manual page 41

Configuring Controllers
PREFEC
POSTFEC BER
OTU TTI Sent
OPERATOR SPECIFIC
OPERATOR SPECIFIC HEX
OTU TTI Received
OPERATOR SPECIFIC
OPERATOR SPECIFIC HEX
OTU TTI Expected
OPERATOR SPECIFIC
OPERATOR SPECIFIC HEX
FEC mode
AINS Soak
AINS Timer
AINS remaining time
The following example shows how to configure TTI on a coherent DSP controller with the sent and expected
strings set to different ASCII strings. The state of the controller goes down and the TIM alarm is raised.
RP/0/RP0/CPU0:ios#config
Fri Mar 15 08:54:29.780 UTC
RP/0/RP0/CPU0:ios(config)#controller coherentDSP 0/1/0/1 tti sent ascii 1234
RP/0/RP0/CPU0:ios(config)#controller coherentDSP 0/1/0/1 tti expected ascii 5678
RP/0/RP0/CPU0:ios(config)#commit
Fri Mar 15 08:56:12.293 UTC
RP/0/RP0/CPU0:ios(config)#exit
RP/0/RP0/CPU0:ios#show controllers coherentDSP 0/1/0/1
Fri Mar 15 08:56:33.910 UTC
Port
Controller State
Inherited Secondary State
Configured Secondary State
Derived State
Loopback mode
BER Thresholds
Performance Monitoring
Alarm Information:
LOS = 1 LOF = 0 LOM = 0
OOF = 0 OOM = 0 AIS = 0
IAE = 0 BIAE = 0
SD_BER = 0
FECMISMATCH = 0 FEC-UNC = 0
Detected Alarms
Bit Error Rate Information
PREFEC
POSTFEC BER
OTU TTI Sent
OPERATOR SPECIFIC
OPERATOR SPECIFIC HEX
OTU TTI Received
BER
ASCII
ASCII
ASCII
SF_BER = 0
BDI = 3 TIM = 1
BER
ASCII
: 7.7E-03
: 0.0E+00
: 1234
:
: 31323334000000000000000000000000
: 00000000000000000000000000000000
: 1234
:
: 31323334000000000000000000000000
: 00000000000000000000000000000000
: 1234
:
: 31323334000000000000000000000000
: 00000000000000000000000000000000
: Soft-Decision 27
: None
: 0h, 0m
: 0 seconds
: CoherentDSP 0/1/0/1
: Down
: Normal
: Normal
: In Service
: None
: SF = 1.0E-5 SD = 1.0E-7
: Enable
: BDI TIM
: 8.2E-03
: 0.0E+00
: 1234
:
: 31323334000000000000000000000000
: 00000000000000000000000000000000
Configuring Controllers
Trail Trace Identifier
41